Frequency; Lamp Setting - NANO CAM NCP-DVRGPS User Manual

3.2.5 Frequency

The Frequency setting is used to set the cameras frequency. To adjust the
frequency, follow the instructions below.
1. Ensure that the DVR is not recording.
2. Press the
3. Press the
4. Use the
Frequency setting and press
5. Use the
OK
button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording
before attempting to access the menu.
2. This setting can only be accessed through the Settings Menu which can be accessed
via the Video and Photo Menus.

3.2.6 Lamp Setting

The Lamp Setting is used to activate or deactivate the LED on the front face of the
DVR. To adjust the light settings, please follow the instructions below.
1. Ensure that the DVR is not recording.
2. Press the
3. Press the
4. Use the
Setting and press
5. Use the
OK
the button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording
before attempting to access the menu.
2. This setting can only be accessed through the Settings Menu which can be accessed
via the Video and Photo Menus.
24
Button to enter the Video or Photo Menu.
M
Button again to enter the Settings Menu.
M
and Buttons to navigate the Settings Menu and highlight the
OK
to select.
and Buttons to highlight your preferred Frequency, then press the
Button to enter the Video or Photo Menu.
M
Button again to enter the Settings Menu.
M
Buttons to navigate the Settings Menu and highlight the Lamp
and
OK
to select.
and Buttons to highlight your preferred either OFF or ON, then press