Exposure; Anti Shaking - NANO CAM NCP-DVRGPS User Manual

3.1.9 Exposure

Exposure is used to manually control the light settings. To change the Exposure
setting follow the instructions below
1. Enter the Photo screen.
2. Press the
3. Use the
setting and press
4. Use the
OK
the button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording
before attempting to access the menu.
2. This setting can only be accessed through the Photo Menu, please make sure that you
are in the Photo screen when you access the menu.

3.1.2.0 Anti Shaking

The Anti Shaking setting uses the on board chipset to correct some of the blur
caused but handheld photography. To enable Anti Shaking follow the instructions
below.
1. Enter the Photo screen.
2. Press the
3. Use the
Shaking setting and press
4. Use the
button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording
before attempting to access the menu.
2. This setting can only be accessed through the Photo Menu, please make sure that you
are in the Photo screen when you access the menu.
20
Button to enter the Photo Menu.
M
and Buttons to navigate the Photo Menu and highlight the ISO
OK
to select.
and Buttons to highlight your required exposure setting, then press
Button to enter the Photo Menu.
M
and Buttons to navigate the Photo Menu and highlight the Anti
OK
to select.
and Buttons to highlight either OFF or ON, then press the
OK