Table of Contents
Advertisement
Enter Setup
Custom Prefix
Enable/Disable Custom Prefix
If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot exceed 10 characters.
Enable Custom Prefix
Set Custom Prefix
To set a custom prefix, scan the Set Custom Prefix barcode and the numeric barcodes corresponding to the hexadecimal
value of a desired prefix, and then scan the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
Example: Set the custom prefix to "CODE"
Check the hex values of "CODE" in the ASCII Table. ("CODE": 43, 4F, 44, 45)
1.
2.
Scan the Enter Setup barcode.
3.
Scan the Set Custom Prefix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5".
4.
5.
Scan the Save barcode.
6.
Scan the Exit Setup barcode.
**
Exit Setup
Set Custom Prefix
**
Disable Custom Prefix
44
Advertisement
Table of Contents
