Checking The Brake Discs - KTM 1050 Adventure Owner's Manual

14 BRAKE SYSTEM
14.2

Checking the brake discs

Warning
Danger of accidents Reduced braking efficiency due to worn brake disc(s).
–
Change the worn brake disc(s) without delay. (Your authorized KTM workshop will be glad to help.)
The ABS lamp  must light up after the ignition is switched on and go out after starting
off. If it does not go out after starting off or if it is lit while riding, this indicates a fault in
the ABS system. In this case, the ABS is no longer enabled and the wheels may lock during
braking. The brake system itself stays functional; only ABS control is not available.
The ABS lamp may also light up if the rotating speeds of the front and rear wheels differ
greatly under extreme riding conditions, for example when making "wheelies" or if the rear
wheel spins. This causes the ABS to switch off.
To reactivate the ABS, the vehicle must be stopped and the ignition switched off. The ABS
is reactivated when the vehicle is switched on again. The ABS lamp goes out when you start
off.
In the "MTC/ABS" menu, ABS can be switched off manually.
Info
After the ignition is switched back on, ABS is reactivated.
124