20
CLEANING, CARE
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake sys-
tem.
–
Clean or dry a dirty or wet brake system by riding and braking gently.
–
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine and on
the brake system to evaporate.
–
Push back the protection caps of the handlebar controls to allow any water that has
penetrated to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
p. 102)
–
Treat bare metal parts (except for brake discs and exhaust system) with corrosion
inhibitor.
Cleaning and preserving materials for metal, rubber and plastic (
–
Treat the painted parts with a mild paint polish.
High-luster polish for paint (
–
Treat the plastic parts and powder-coated parts with a mild cleaning and care product.
Paint cleaner and polish for high-gloss and matte finishes, bare metal and plastic
surfaces (
p. 210)
–
Oil the ignition/steering lock, tank lock, and seat lock.
p. 210)
184
p. 209)