MEANS OF REPRESENTATION Symbols used The meaning of specific symbols is described below. Indicates an expected reaction (e.g. of a work step or a function). Indicates an unexpected reaction (e.g. of a work step or a function). Indicates a page reference (more information is provided on the specified page). Indicates information with more details or tips.
Page 5
SETUP Unpacking and setting up the vehicle Preparatory work – Remove the box. Main work – Remove the adhesive tape in the upper area of the motorcycle. 202178-10 – Roll down the film at the sides. Info To avoid damaging the motorcycle during unpacking, leave the other films on the vehicle until you have finished work on the vehicle.
Page 6
SETUP – Remove the film from the headlight. Position the screen. Mount and tighten screws 202183-10 – Mount and tighten the rear mirror on both sides. 202184-10 – Mount reflector on retaining plate with spring washers – Mount the retaining plate on the license plate holder. Mount the license plate holder.
Page 7
Recharge the battery. ( p. 6) – Store the tool set below the seat. – Remove the remaining films. – Refuel. ( p. 8) – Print out the current PDI form found on KTM DEALER.NET and perform the delivery inspection.
Page 8
The battery is maintenance-free, i.e., the acid level does not have to be checked. If the battery is not charged using the KTM battery charger, the battery must be removed for charging. Otherwise, overvoltage may damage electronic components. Charge the battery according to the instructions on the battery housing.
Page 9
WORK Preparatory work – Switch off all power consumers and switch off the engine. – Remove the seat. ( p. 6) Main work – Pull locking mechanism in the direction of the arrow. – Fold open cover S00302-10 – Disconnect the negative cable of the battery to avoid damage to the motorcy- cle's electronics.
Page 10
WORK – Set the time and date. Refueling Danger Fire hazard Fuel is highly flammable. – Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately. –...
Page 11
WORK – Lift cover of the filler cap and insert ignition key in the fuel tank lock. S00225-10 Note Danger of damage Ignition key breakage. – To take pressure off of the ignition key, push down on the filler cap. Damaged ignition keys must be replaced.
Page 14
SUBSTANCES Super unleaded (ROZ 95/RON 95/PON 91) According to – DIN EN 228 (ROZ 95/RON 95/PON 91) Guideline – Only use unleaded super fuel that matches or is equivalent to the specified fuel grade. – Fuel with an ethanol content of up to 10 % (E10 fuel) is safe to use. Info Do not use fuel containing methanol (e.