Fuses - Arctic Cat BEARCAT F5 Operator's Manual

Hide thumbs Also See for BEARCAT F5:
Table of Contents

Advertisement

6. If the meter reads less than specified
voltage, charge the battery using the
following guidelines.
A. When using an automatic battery
charger, always follow the char-
ger manufacturer's instructions.
B. When using a constant-current
battery charger, use the follow-
ing Battery Charging Chart.
CAUTION
Never exceed the standard charging
rate.
! WARNING
An overheated battery could explode
causing
severe
Always monitor charging times and
charge rates carefully. Stop charging
if the battery becomes very warm to
the touch. Allow it to cool before
resuming charging.
Battery Charging Chart
(Constant-Current Charger)
Battery
Charge
Voltage
State
(DC)
12.5 (mini-
100%
mum)
12.2-12.4
75%-99%
12.0-12.2
50%-74%
11.0-11.9
25%-49% 13 hours (minimum)
11.5 or less
0-24%
NOTE: If the battery voltage is 11.5
DC Volts or less, some chargers may
"cut off" and fail to charge. If this
occurs, connect a fully charged
booster battery in parallel (positive
to positive and negative to negative)
for a short period of time with the
charger connected. After 10-15 min-
utes, disconnect the booster battery
leaving the charger connected and
the charger should continue to
charge. If the charger "cuts off,"
replace the battery.
7. After charging the battery for the
specified time, remove the battery
charger and allow the battery to sit
for 1-2 hours.
injury
or
death.
Charge Time
Required (at 1.5-
2.0 Amps)
None
3-6 hours
5-11 hours
20 hours (minimum)
8. Connect the multimeter and test the
battery voltage. The meter should
read no less than 12.5 DC Volts. If
the voltage is as specified, the bat-
tery is ready for service.
NOTE: If voltage in step 8 is below
specifications, charge the battery an
additional 1-5 hours; then retest.
Recheck electrolyte level (standard
battery) and the battery is ready for
service.
9. Place the battery into position in the
snowmobile; then coat the battery
posts and cable ends with a light
coat of multi-purpose grease.
CAUTION
Before installing the battery, make
sure the ignition switch is in the OFF
position.
10. Connect the battery cables (positive
cable first).
CAUTION
Connecting cables in reverse (posi-
tive to negative and negative to posi-
tive) can cause serious damage to
the electrical system.

Fuses

Fuses protect the snowmobile electrical
system from overloading. If electrical
parts in the snowmobile are not working,
the system may have been overloaded and
caused a blown fuse. Before repairing or
replacing any electrical part, check the
appropriate fuses. If a fuse blows (opens a
circuit), all the parts of the snowmobile
that use that circuit will not work.
Once which fuse to check has been deter-
mined, perform the following steps:
1. Open the right-side access panel;
then on the 1100 cc, remove the fuse
panel cover (the fuse panel is located
behind the battery). On the F5/570
cc, remove the fuse holder cover and
disconnect the fuse.
41

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bearcat t seriesBearcat f570

Table of Contents