Removable Light Bar (Bearcat Z1 Xt Gs) - Arctic Cat BEARCAT F5 Operator's Manual

Bearcat XT
These snowmobiles are equipped with a
removable rear seat (and on the LTD, a
removable third seat) to allow for addi-
tional cargo space when no passenger is
being carried.

NOTE: If additional cargo is being
added, maximum weight on the
snowmobile
cargo) should not exceed the maxi-
mum limitation set for each snowmo-
bile. See the chart in the Suspension
- Overload Springs sub-section in
the Maintenance section for details.
Also, the overload springs should be
engaged.
To remove the rear seat (and third seat on
the LTD), use the following procedure:
1. Remove the four pins securing the rear
seat to the seat/Speedrack mount.

NOTE: On the LTD, also remove the
two pins securing the third seat to the
seat/Speedrack mount; then lift the
third seat up and away.
2. Lift on the back of the rear seat and
move it rearward to remove it from
the mount.
To install the rear seat (and on the LTD,
the third seat), use the following proce-
dure:
(operator/passenger/
743-329A
0745-131
1. Place the rear seat into position on
the mount making sure the four pin
holes are properly aligned with the
mounting location on mount.
2. Install the four pins making sure
they are properly seated.

NOTE: On the LTD, place the third
seat into position on the mount mak-
ing sure the two pin holes are prop-
erly aligned with
location on the mount; then install
the two pins making sure they are
properly seated.
! WARNING
Make sure the rear seat (and on the
LTD, the third seat) is securely locked
in place with the pins before carrying
a passenger or personal injury may
result.
Removable Light Bar
(Bearcat Z1 XT GS)
This snowmobile is equipped with a
removable light bar. To remove and
install, use the following procedure.
1. Disconnect the light bar harness
connector; then remove the four pins
securing the bar to the mount.
2. Remove the light bar.
3. Place the light bar into position on
the mount; then secure with the four
pins.
4. Connect the light bar harness con-
nector.
the mounting
0745-805
21