12
SERVICE WORK ON THE CHASSIS
12.14
Installing the lower triple clamp
(EXC‑F Factory Edition, EXC‑F Six Days)
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal
–
Slide on protective ring
B01604-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws
Guideline
Remaining screws, chassis
B01230-10
(EXC‑F Factory Edition)
–
Position the fork legs.
Position bleeder screws
S00627-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00139-10
–
Tighten screw
Guideline
Screw, top steering head
S00637-10
p. 122)
and O-ring
but do not tighten yet.
.
toward the front.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
.
.
is correctly positioned.
.
M6
10 Nm (7.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm
(8.9 lbf ft)
56