Nm (7.4 Lbf Ft) - KTM 250 EXC-F Owner's Manual

18 SERVICE WORK ON THE ENGINE
–
Remove screws
L02482-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
L02480-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
L02481-10
–
Remove the oil filler plug
engine oil.
Engine oil
L02476-10
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
Finishing work
(EXC‑F Factory Edition, EXC‑F AU, EXC‑F Six Days)
–
Install the engine guard. (
–
Check the engine oil level. (

. Take off the oil filter cover with the O-ring.

out of the oil filter housing.

with the O-ring from the clutch cover and fill up with
1.2 l (1.3 qt.)
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 74)
p. 102)
M6

10 Nm (7.4 lbf ft)

Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 120)
formance
104

.
p. 120)