Nm (7.4 Lbf Ft); Loctite - KTM 250 EXC-F Owner's Manual

Hide thumbs Also See for 250 EXC-F:
Table of Contents

Advertisement

12
SERVICE WORK ON THE CHASSIS
Check the chain sliding guard for wear.
»
If the bottom edge of the chain bolt is in line with or below the chain sliding
guard:
Change the chain sliding guard.
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain sliding
guard
L02465-01
Check the chain sliding piece for wear.
»
If the bottom edge of the chain bolt is in line with or below the chain sliding
piece:
Change the chain sliding piece.
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
Tighten the screw of the chain sliding piece.
Guideline
Screw, chain sliding piece
L02466-01
Check the chain guide for wear.
Info
Wear is visible on the front of the chain guide.
»
If the light part of the chain guide is worn:
Change the chain guide.
401760-01
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
M00104-01
Finishing work
Remove the motorcycle from the lift stand. (
M6
6 Nm
(4.4 lbf ft)
M8
M6
M6
p. 48)
71

Loctite

®
243™
15 Nm
(11.1 lbf ft)
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents