Changing The Fuses Of Individual Power Consumers; Removing Headlight Mask With Headlight - KTM 250 EXC-F Owner's Manual

15 ELECTRICAL SYSTEM
15.5

Changing the fuses of individual power consumers

Info
The fuse box containing the fuses of individual power consumers is located under the seat.
15.6

Removing headlight mask with headlight

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Open fuse box cover
L02457-10
–
Remove the defective fuse.
Guideline
Fuse 1 - 10 A - EFI control unit
Fuse 2 - 5 A - fuel pump
Fuse 3 - 10 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 4 - 10 A - horn, brake light, turn signal, radiator fan (optional)
Fuses res - 10 A - spare fuse
Fuses res - 5 A - spare fuse
L02458-10
Info
A defective fuse can be identified by the burned-out fuse wire
Warning
Fire hazard The electrical system can be overloaded if the wrong fuses are
used.
–
–
Use spare fuses with the correct rating only.
Fuse (75011088010) (
Fuse (58011109105) (
Tip
Replace the spare fuse in the fuse box so that it is available if needed.
–
Check that the power consumer is functioning properly.
–
Close the fuse box cover.
Finishing work
–
Mount the seat. (
–
Switch off all electrical equipment.
–
Remove screw
–
Release rubber straps
M00143-10
p. 61)

.
Use only fuses with the prescribed amperage. Never bypass or repair
fuses.
p. 116)
p. 116)
p. 62)

and take off the clamp.

. Slide the headlight mask up and swing it forward.
92

.