Table of Contents
Advertisement
22
TROUBLESHOOTING
Faults
The engine turns but does not start
The engine dies during the trip
The engine warning lamp lights
up/flashes
The ABS warning lamp lights up
High oil consumption
The battery is discharged
Possible cause
Defect in the fuel injection system
The fuel quality is insufficient
Lack of fuel
Defect in the fuel injection system
Defect in the fuel injection system
The ABS fuse is blown
Large difference in wheel speeds of the
front and rear wheels
Malfunction in ABS
The engine oil level is too high
The engine oil is too thin (low viscos-
ity)
The hazard warning flasher is switched
on
The battery is not being charged by the
alternator
The ignition was not switched off while
the vehicle was parked
Action
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Add suitable fuel.
–
Refuel. (
p. 84)
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Change the fuses in the fuse box. (
–
Stop the vehicle, switch off the ignition, and
start it again.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Check the engine oil level. (
–
Change the engine oil and oil filter and clean the
oil screens.
(
p. 166)
–
Switch off the hazard warning flasher.
–
Recharge the battery.
–
Check the charging voltage.
–
Recharge the battery.
180
p. 147)
p. 165)
(
p. 140)
(
p. 140)
Advertisement
Table of Contents
