12
SERVICE WORK ON THE CHASSIS
12.10
Removing the lower triple clamp
12.11
Installing the lower triple clamp
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
M01017-10
(XCF‑W)
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws
–
Release screw
handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
M00989-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
M00990-10
(All EXC‑F models)
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal
–
Slide on protective ring
B01604-10
. Remove protective ring
(
p. 87)
(
p. 50)
p. 61)
and hang the voltage regulator to one side.
and remove screw
. Take off the upper triple clamp with the
. Remove protective ring
p. 126)
and O-ring
.
p. 95)
p. 49)
.
is correctly positioned.
.
54