Removing The Lower Triple Clamp (Exc-F Eu, Xcf-W) - KTM 450 EXC-F 2020 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.9
68
V01784-11
K00546-10
Removing the lower triple clamp
V01785-10
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
3
Tighten screws .
Guideline
Screw, bottom
triple clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front M8
brake caliper
–
Mount the cable tie.
–
Position the brake line, wiring harness, and clamp. Mount and
5
tighten screws .
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
(EXC‑F EU, XCF‑W)
Preparatory work
–
Press and hold the switch-off button
idling until the engine stops.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs. (
–
Remove front fender. (
–
Remove the handlebar cushion.
Main work
–
Open the cable holder in front of the left radiator and detach
the wiring harness.
–
1
Loosen screw .
–
2
Remove screw .
–
Take off the upper triple clamp with the handlebar and hang
them to the side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
M8 17 Nm
(12.5 lbf ft)
M8 15 Nm
(11.1 lbf ft)
25 Nm (18.4 lbf ft)
Loctite
( p. 116)
p. 128)
p. 129)
while the engine is
p. 127)
p. 64)
( p. 115)
p. 66)
p. 76)
4
.
243™
®