KTM 250 EXC-F Owner's Manual page 58

12 SERVICE WORK ON THE CHASSIS
(EXC‑F Six Days)
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and
tighten screws
Guideline
Remaining screws, chassis
S00652-10
–
Position the fork legs.
Bleeder screws
S00627-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00139-10
–
Tighten screw
Guideline
Screw, top steering head
S00637-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
S00638-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
M00139-11
 but do not tighten yet.

.

are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.

.

.

.
M8

.
M6 10 Nm
(7.4 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M20x1.5 12 Nm
(8.9 lbf ft)
17 Nm Loctite ®
(12.5 lbf ft)
M8 17 Nm
(12.5 lbf ft)

.
56
243™