12
SERVICE WORK ON THE CHASSIS
12.7
Removing the fork protector
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00138-11
(XCF‑W)
–
Position the fork legs.
Bleeder screws
M00992-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00991-11
–
Position the brake caliper and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable binder.
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
K00088-10
Finishing work
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Remove screws
–
Remove screws
–
Remove screws
S00820-10
.
.
are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
.
.
M8
(
p. 87)
p. 97)
and take off the clamp.
on the left fork leg and take off the left fork protector.
on the right fork leg and take off the right fork protector.
M8
17 Nm
(12.5 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M8
15 Nm
(11.1 lbf ft)
.
25 Nm
Loctite
®
(18.4 lbf ft)
p. 96)
52
243™
.