12
SERVICE WORK ON THE CHASSIS
12.48
Removing the engine guard
12.49
Installing the engine guard
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
M00208-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
L02463-10
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
M00209-10
–
Turn quick release
guard.
L02452-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Turn quick release
L02453-10
.
with membrane
.
with the appropriate hydraulic fluid.
p. 124)
.
counterclockwise until it disengages. Remove the engine
clockwise all the way.
and mount bleeding
of the master
4 mm (0.16 in)
77