Riding Instructions; Checks And Maintenance Work When Preparing For Use; Starting - KTM 250 EXC-F Owner's Manual

9

RIDING INSTRUCTIONS

9.1

Checks and maintenance work when preparing for use

Info
Before riding the vehicle, always check its condition and operating safety.
The vehicle must be in perfect technical condition when used.
–
Check the engine oil level. (
–
Check the electrical system.
–
Check the brake fluid level of the front brake. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check that the brake system is functioning properly.
–
Check the coolant level. (
–
Check for chain dirt accumulation. (
–
Check the chain, rear sprocket, engine sprocket and chain guide. (
–
Check the chain tension. (
–
Check the tire condition. (
–
Check the tire air pressure. (
–
Check the spoke tension. (
–
Clean the dust boots of the fork legs. (
–
Bleed the fork legs. (
–
Check the air filter.
–
Check the settings of all controls and ensure that they can be operated smoothly.
–
Check all screws, nuts, and hose clamps regularly for tightness.
–
Check the fuel supply.
9.2

Starting

Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
p. 106)
p. 79)
p. 83)
p. 80)
p. 84)
p. 101)
p. 71)
p. 71)
p. 89)
p. 90)
p. 90)
p. 50)
p. 49)
–
Take the motorcycle off of side stand
band
–
Shift transmission to neutral.
(EXC‑F AU)
–
Turn the emergency OFF switch to the position
Condition
Ambient temperature: < 20 °C (< 68 °F)
–
Pull the idle speed adjusting screw all the way out.
401944-10
–
Press the electric starter button or press the kick starter robustly through its full
range.
400733-01
p. 73)
 .
Info
Press the electric starter button for at most 5 seconds. Wait for a least 5
seconds before trying again.
Warning lamp FI lights up briefly as a functional control when starting.

and secure the side stand with rubber
.
34