12
SERVICE WORK ON THE CHASSIS
12.8
Installing the fork protector
12.9
Removing the lower triple clamp
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
S00820-11
(All EXC‑F models)
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
(EXC‑F EU/AU/BR)
–
Open the cable holder in front of the right radiator and detach the wiring har-
ness.
–
Remove screws
–
Remove screw
handlebar and set it aside.
S00815-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
S00816-10
(EXC‑F Six Days)
–
Open the cable holder in front of the right radiator and detach the wiring har-
ness.
–
Remove screws
–
Remove screw
handlebar and set it aside.
S00830-10
(
p. 87)
(
p. 50)
p. 61)
and hang the voltage regulator to the side.
. Remove screw
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
. Remove protective ring
and hang the voltage regulator to the side.
. Remove screw
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 95)
p. 49)
. Take off the upper triple clamp with the
.
. Take off the upper triple clamp with the
53
.
.
.