KTM 450 XC-F Owner's Manual page 89

17 SERVICE WORK ON THE ENGINE
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
102234-10
–
Position oil screen
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
102235-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
102236-10
–
Remove screws
102237-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
102238-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Lubricate the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
102239-10

with the short oil screen and the O-rings.

with the O-rings on a pin wrench.

with the O-ring.


. Remove the oil filter cover with the O-ring.

out of the oil filter housing.
M20x1.5 15 Nm
(11.1 lbf ft)
M20x1.5 15 Nm
(11.1 lbf ft)
with the magnet and a new seal ring.
M12x1.5 20 Nm
(14.8 lbf ft)
M6 10 Nm (7.4 lbf ft)
87

.