KTM 450 XC-F Owner's Manual page 37

10 TUNING THE CHASSIS
Main work
–
Remove screws
it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
–
Place the handlebar support in the required position. Mount and tighten

screws
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
102145-10
–
Position the handlebar clamps. Mount screws
that both parts touch at the front and tighten all of the screws.
Guideline
Screw, handlebar clamp
Finishing work
–
Mount the handlebar cushion.

. Take off the handlebar clamps. Remove the handlebar and lay

. Remove handlebar support
 and push through nuts
.
M10

.
 from below.
Loctite
40 Nm
(29.5 lbf ft)

. Screw the handlebar clamps so
M8 20 Nm
(14.8 lbf ft)
35
243™
®