Blind Plate Assembly - Sony Handycam DCR-PC115 Service Manual

2-14.BLIND PLATE ASSEMBLY

(Remove the FJ-035 board referring to section 2-4 before starting disassembling.)
The +P2 (0-No.) screws (M1.7 × 2.5) are MEC-processed. If the screws that are once removed,
Note:
are re-used, the screws may be loosened.
When re-assembling the mechanism, use the new +P2 (0-No.) screws (M1.7 × 2.5).
Two screws
1
(M1.7 × 2.5),
0-No, +p2
(Note)
2-15.PD-148B BOARD, INVERTER TRANSFORMER UNIT
LCD cabinet (R)
3
assembly
2 Two claws
Two screws
5
A
(M1.7 × 2.5),
lock ace, p2
6 Two claws
B
LCD cabinet (L)
7
assembly
FP-387 flexible board
2
1 Four claws
If the FP-387 flexible board is
pulled in the direction of the
arrow A , the claws at the four
locations will be released.
2 Blind plate assembly
Remove it while taking care so that it must not
be caught by the flexible board and harnesses,
by pulling it in the direction of the arrow.
2 Panel insulating
Two screws
1
(M1.7 × 2.5),
lock ace, p2
B
8
A
Two screws
4
(M1.7 × 2.5),
MI
DCR-PC115/PC115E/PC120BT/PC120E
PRECAUTION DURING
FP-387 FLEXIBLE BOARD
INSTALLATION (1)
Install the flexible wire to the blind plate
so that it covers the harness (PT-128).
A A
Remove the blind plate assembly
after opening the LCD panel.
sheet
4 Remove the
three solderings
qs PD-148B board
8 PCB clip
6 Two claws
2-13
Blind plate
assenbly
Harness (PT-128)
qa Inverter transformer unit
Screw
5
(M1.7 × 2.5),
lock ace, p2
1 Harness
(PT-128) (16P)
9 PCB clip
q; Remove the
six solderings
Back light
7
(Cold cathode
fluorescent tube)
3 Liquid crystal
indicator module (24P)