Mechanical Shutter Adjustment; Steady Shot Check - Sony Handycam DCR-PC115 Service Manual

14. Mechanical Shutter Adjustment

Adjustment Page F
Adjustment Address 5C to 75
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Input the following data to page: F, addresses: 5C to 75.
Note: Press the PAUSE button of the adjustment remote commander each
time to set the data.
Address Data
5C 70
5D 9E
5E A6
5F A5
60 A8
61 20
62 A7
63 0C
64 6E
65 09
66 B5
67 07
68 5B
69 06
6A 7A
6B 05
b6C 8F
6D 2E
6E 6F
6F 4B
70 91
71 46
72 7B
73 39
74 83
75 33
3) Select page: 0, address: 01, and set data: 00.
RadarW RadarW RadarW RadarW RadarW

15. Steady Shot Check

Precautions on the Parts Replacement
There are two types of repair parts.
Replace the broken sensor with a same type sensor. If replace with
other type parts, the image will vibrate up and down or left and
right during hand-shake correction operations. After replacing, re-
adjust according to the adjusting method after replacement.
Precautions on Angular Velocity Sensor
The sensor incorporates a precision oscillator. Handle it with care
as if it dropped, the balance of the oscillator will be disrupted and
operations will not be performed properly.
Note1: Displayed data of the adjustment remote commander.
Switch setting:
1)
2)
Adjusting method:
Order Page Address Data
Note2: Don't move the camcorder.
Processing after Completing Adjustments
Order Page Address Data
5-31
DCR-PC115/PC115E/PC120BT/PC120E
RadarW RadarW RadarW RadarW RadarW
Type A: ENC03LA
Type B: ENC03LB
Subject Arbitrary
Measurement Point Display data of page 1 (Note1)
Measuring Instrument Adjustment remote commander
Specified Value 1B00 to 2500
1 : XX : XX
Display data
STEADY SHOT (Menu display) ...................................... ON
ZOOM ......................................................................... Center
1 6 04 11
2 1
3 6 04 12
4 1
1 6 04 00
Procedure
Pitch sensor check
(VM-027 board SE3450)
Set the data.
Check that the display data
(Note1) satisfies the specified
value. (Note2)
Yaw sensor check
(VM-027 board SE3451)
Set the data.
Check that the display data
(Note1) satisfies the specified
value. (Note2)
Procedure
Set the data.