Cabinet (L) Section - Sony Handycam DCR-PC115 Service Manual

DCR-PC115/PC115E/PC120BT/PC120E

2-2. CABINET (L) SECTION

Note: The power capacitor (C2010) of the flash unit is charged to the high tension voltage as high as 300 V at a maximum.
You will get electrical shock when you touch the Flash unit (MC) mounted with the terminal of the charged capacitor.
The charged potential remains even after the main power of the machine is turned off.
Discharge the remaining power in the capacitor referring to Service Note (page 8).
3 HS
Screw
1
(M1.7 × 2.5),
lock ace, p2
2 Two claws
4
PRECAUTION DURING CABINET (L) SECTION
INSTALLATION
When installing the Cabinet (L) section to the Cabinet (R) section
and to the VTR complete, install it while the "Night-Shot switch
outside the Cabinet (L) section" and "Night-Shot switch on top of
the Lens Device" are facing upward.
OFF
ON
Night-Shot switch outside the
Cabinet (L) section
PRECAUTION DURING
JACK ORNAMENTAL COVER
ASSEMBLY INSTALLATION
Be careful that top of the Jack
ornamental cover assembly does not
hang over the IR window assembly.
OK
Cabinet
IR window
assembly
Jack ornamental
cover assembly
5 Jack ornamental
cover assembly
Three screws
(M1.7 × 2.5),
lock ace, p2
Night-Shot switch on top of
the Lens Device
NG
Screw
1
(M1.7 × 2.5),
lock ace, p2
Two screws
3
(M1.7 × 4),
lock ace, p2
7 Cabinet (L) section
Lens Device
2-4
5 Control switch block
(FK-1850) (51P)
6 Cabinet (R) section,
VTR complete
Two screws
2
(M1.7 × 2.5),
lock ace, p2
Screw
4
(M1.7 × 2.5),
lock ace, p2
(Caution:
High voltage)
Flash unit (MC)