FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Configuring LLDP Using CLI Commands
The following commands are used to set the fields in the LLDP Properties
page.
Table 17-1. LLDP Properties CLI Commands
CLI Command
lldp run
no lldp run
lldp timer seconds
no lldp timer
lldp hold-multiplier number
no lldp hold-multiplier
lldp reinit seconds
no lldp reinit
lldp tx-delay seconds
no lldp tx-delay
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 0 / 3 0 / 1 3 - F O R P R O O F O N LY
Contax\sources\CxUGSwitching_LLDP.fm
Dell PowerConnect 55xx Systems User Guide
Description
Enables enable LLDP .
Use the no form of this command to
disable LLDP .
Specifies how often the software sends
LLDP updates.
Use the no form of this command to
restore the default configuration.
Specifies the time that the receiving
device should hold a Link Layer Discovery
Protocol (LLDP) packet before discarding
it.
Use the no form of this command to
restore the default configuration.
Specifies the minimum time an LLDP
port will wait before reinitializing.
Use the no form of this command to revert
to the default setting.
Specifies the delay between successive
LLDP frame transmissions.
Use the no form of this command to
restore the default configuration.
545