Dell PowerConnect 5500 Series System User's Manual page 381

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
– Flow Sampling Average Sampling Rate(1024–1073741823) — If x is
entered, a flow sample will be taken for each x frames.
– Flow Sampling Receiver Index — Select one of the indices that was
defined in the sFlow Receivers Settings pages.
Flow Sampling Maximum Header Size (20–256) — Maximum
–
number of bytes that should be copied from a sampled packet.
– Counters Sampling — Enable/disable counters sampling. Flow
sampling cannot be disabled if Flow Sampling is disabled
Counters Sampling Interval (15–86400) — If x is entered, this
–
specifies that a counter sample will be taken for each x seconds.
– Counters Sampling Receiver Index — Select one of the indices that
was defined in the sFlow Receivers Settings pages.
Configuring sFlow Interfaces Using the CLI Commands
The following table summarizes the CLI commands for configuring sFlow
interfaces.
Table 9-74. sflow Interface CLI Commands
CLI Command
sflow flow-sampling rate
receiver-index [max-header-size
bytes]
no sflow flow-sampling
sflow counters-sampling interval
receiver-index
no sflow counters-sampling
The following is an example of the CLI commands:
console(config)# interface gi2/0/3
console(config-if)#sflow flow-sampling 1024 1
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 0 / 3 0 / 1 3 - F O R P R O O F O N LY
Contax\sources\CxUGSystemConfig.fm
Dell PowerConnect 55xx Systems User Guide
Description
Enables sFlow Flow sampling and
configure the average sampling rate
of a specific port.
Use the no form of this command to
disable Flow sampling.
Enable sFlow counters sampling and
to configure the maximum interval of
a specific port.
Use the no form of this command to
disable sFlow Counters sampling.
381