Dell PowerConnect 5500 Series System User's Manual page 303

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
• Peer-to-Peer — Point-to-point communications with a NetBIOS
name server are used to register and resolve computer names to IP
addresses.
Mixed — A combination of b-node and p-node communications
•
is used to register and resolve NetBIOS names. M-node first uses
b-node; then, if necessary, p-node. M-node is typically not the best
choice for larger networks because its preference for b-node
Broadcasts increases network traffic.
• Hybrid — A hybrid combination of b-node and p-node is used.
When configured to use h-node, a computer always tries p-node
first and uses b-node only if p-node fails. This is the default.
SNTP Server — Enter the IP address of the time server for the DHCP
–
client.
– Next Server — Enter the IP address of the next server in the boot
process of a DHCP client. If the next server in the boot process is not
configured, the DHCP server uses inbound interface helper addresses
as boot servers.
– Next Server Name — Enter the name of the next server in the boot
process.
– Image File Name — Enter the name of the file that is used as a boot
image.
Configuring Network Pool Using CLI Commands
The following table summarizes the CLI commands for defining a pool of
addresses on the DHCP server.
Table 9-53. Network Pool CLI Commands
CLI Command
ip dhcp pool network name
no ip dhcp pool network name
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 0 / 3 0 / 1 3 - F O R P R O O F O N LY
Contax\sources\CxUGSystemConfig.fm
Description
Configures a DHCP address pool on a
DHCP Server and enters DHCP Pool
Configuration mode.
Use the no form of this command to remove
the address pool.
Dell PowerConnect 55xx Systems User Guide
303