Cork Separator Pad - Tektronix PHASER 560 Service Manual

8
FRU Disassembly/Assembly

Cork separator pad

8-10 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
Required tools
Small, flatblade screwdriver
The cork separator pad should be replaced whenever the multi-purpose pick
roller is replaced. The expected life of each is about 30k prints.
1. Turn off the printer.
2. Open the left side door to access the paper feeder. Slide out the paper
feeder.
3.
Grasp the paper guide and push in and down to the bottom of it
travel, then tilt it forward.
4. With a small, narrow, flat-blade screwdriver, reach behind the cork
separator pad and free the two retaining hooks hold the separator pad
in place. Note the spring is under tension. Remove the separator pad
and spring.
5. Install a new cork separator pad.
6. Copy count. Use the Service tests discussed in the topic "Printer
self-diagnostics" on page 9-6 to reset the cork pad and pick roller's
copy count to zero.
manuals search engine