Dhcp Server; Spanning Tree - TRENDnet TEW-735AP User Manual

TRENDnet User's Guide

DHCP Server

The TEW-735AP is equipped with a DHCP server to assign IPv4 addresses
dynamically. The assigning IP address range must be in the subnet that
was used in IP Settings. By default, the DHCP server is disabled. If you
want to enable it, select Enabled from the DHCP Server drop down list.
Enter the requested information and click Apply to save the change and
activate DHCP server.
DHCP Server
DHCP Server : Choose Enabled or Disabled from the drop
down list.
Lease Time : How long the assigning IP will be valid.
Start IP : Starting IP address of DHCP pool.
End IP : Last IP address of DHCP pool.
First DNS
Primary DNS server address you want to
Address :
assign with DHCP lease.
Second DNS
Secondary DNS server address you want to
Address :
assign with DHCP lease.
© Copyright 2015 TRENDnet. All Rights Reserved.

Spanning Tree

The TEW-735AP is designed for end point access as well as backbone
connection. To avoid network looping, you can enable 802.1d Spanning
Tree Protocol (STP).
Spanning Tree
Spanning Tree
Enable or disable 802.1d spanning tree
Status:
protocol to avoid network looping.
Bridge Hello
The time between each bridge protocol
Time:
data unit (BPDU). Default: 2 sec.
Bridge Max Age: Maximum time a BPDU kept in bridge.
Default: 20 sec
Bridge Forward
The time spent in listen and learning state.
Delay:
Default: 15 sec.
Bridge Priority: Priority number for root bridge selection.
(MAC number is listed on Status > Main
page)
Apply: Click this button to save and activate
Cancel: Click this button to abandon the change
TEW-735AP
21