Advanced - TRENDnet TEW-735AP User Manual

TRENDnet User's Guide

Advanced

Fine tuning your wireless settings on this page.
Fragment
Packets over the specified size will be
Threshold:
fragmented in order to improve performance
on noisy networks. Specify a value between
256 and 2346. The default value is 2346.
RTS
Packets over the specified size will use the
Threshold:
RTS/CTS mechanism to maintain performance
in noisy networks and preventing hidden
nodes from degrading the performance.
Specify a value between 0 and 2347. The
default value is 2347.
Beacon
Beacons are packets sent by a wireless access
Interval:
point to synchronize wireless devices. Specify
a Beacon Interval value between 24 and 1024.
The default value is set to 100 milliseconds.
© Copyright 2015 TRENDnet. All Rights Reserved.
DTIM
A DTIM is a countdown informing clients of
Period:
the next window for listening to broadcast
and multicast messages. When the wireless
Access Point has buffered broadcast or
multicast messages for associated clients, it
sends the next DTIM with a DTIM Period
value. Wireless clients detect the beacons and
awaken to receive the broadcast and multicast
messages. The default value is 1. Valid settings
are between 1 and 10.
Data rate: You can select a data rate from the drop- down
list, however, it is recommended to select auto.
In auto mode, TEW735AP will choose the
maximum data rate to fit the instant wireless
channel quality automatically.
N Data Rate: Select different 802.11n Modulation and
Coding Scheme (MCS) against particular
wireless noise or select auto for the TEW-
735AP to select MCSs dynamically.
Channel
Set channel bandwidth to 1) Dynamic select 20
Bandwidth:
MHz and 40MHz channels or 2) fixed in 20MHz
channels only.
Preamble
Select a short or long preamble. For optimum
Type:
performance, it is recommended to also
configure the client device to the same
preamble type.
CTS
Clear to Send, CTS, can be set to always
Protection:
enabled, auto, or disabled. By enabling CTS, the
Access Point and clients will wait for a 'channel
cleared' signal before transmitting. The
recommended setting is to auto.
Tx Power: Wireless signal transmission power. Setting
transmission power to an appropriate value
can make your multiple AP deployment easier.
The default value is 26 dBm for FCC version
TEW-735AP
26