Setup And Installation; Assembling The Rear Support; Mounting The Platter, Drive Belt And The Record Clamp - Pro-Ject Audio Systems VT-E BT L Instructions For Use Manual

SETUP AND INSTALLATION

PART 1 – DESKTOP USE
1.

ASSEMBLING THE REAR SUPPORT

Remove the rear support panel (18) from the packaging and prepare two M6x35 screws for mounting.
Using the screwdriver, carefully tighten the screws to fix the rear support panel on the turntable's chassis (5)
as shown in the following illustration.
2. MOUNTING THE PLATTER, DRIVE BELT AND RECORD CLAMP
With the rear support (18) mounted and the turntable in vertical position, install the platter (3) and the drive
belt (4) as shown in following illustration.
After placing the record on the platter, it is necessary to tighten the screw-able record
clamp (6) onto the platter spindle.
© Pro-Ject Audio Systems · Pro-Ject VT-E BT L · Revision 2016.07.27
7