Table of Contents
Advertisement
SETUP AND INSTALLATION
1.
FEET ASSEMBLY
Remove the front right foot (11 –accessories list) from the plastic bag. Carefully lift the turntable and
screw the foot into the thread pin from the bottom of the turntable. Balance the turntable by using a
spirit level before next steps.
2.
PLATTER AND DRIVE BELT ASSEMBLY
Install the drive belt (5) and the main platter (1) as shown in following ilustration.
3.
MOUNTING AND CONNECTING THE CARTRIDGE
All cartridges with half inch mounting holes can be mounted. Leave the needle's protection cover on,
fit the cartridge to the headshell by using the supplied screws by passing one screw through each slot
in the headshell (12). Do not tighten the nuts yet.
Connect the tonearm wires with the cartridge pins as follows:
left channel positive (L+)
white
red
right channel positive (R+)
green
right channel return (R-)
blue
left channel return (L-)
The full sound quality of the record player can only be achieved if the cartridge is adjusted correctly.
Particular tools like the Pro-Ject Audio Systems alignment tool are required to accomplish this job properly.
If you are not well acquainted with the adjustment of cartridges, please call for the willing help of your
Pro-Ject Audio Systems dealer.
6
© Pro-Ject Audio Systems · Pro-Ject X2 · Revision 2019.08.06
Hide quick links:
Advertisement
Table of Contents
