Pro-Ject Audio Systems VTA it Setup Manual

Download this manual

Setup Guide

How to install VTA it

Difficulty

Expert

Steps

30 min

Time

Install at your own risk!

The installation of "VTA it" should be done by an experienced

technician. Unauthorized installations void the warranty.

Find a dealer:

www.project-audio.com/en/find-a-dealer/

Required tools:

To install "VTA it" you need to unscrew the tonearm-base and

the RCA-box of your turntable.

These steps require following tools:

- Philips #1 Screwdriver

- 5.5mm Nut Driver Wrench

Page 1 Expert Steps 30 min Time Install at your own risk! The installation of “VTA it“ should be done by an experienced technician. Unauthorized installations void the warranty. Find a dealer: www.project-audio.com/en/find-a-dealer/ Required tools: To install “VTA it“ you need to unscrew the tonearm-base and the RCA-box of your turntable.
Page 2 Remove the counterweight and anti-skating weight from the Remove the main platter. Bring the turntable in an upright position to have access to Underside: remove upper screw while holding the tonearm tonearm. Secure the tonearm using the supplied red wire. both the upper- and underside.