Set-Up; Platter Installation - Pro-Ject Audio Systems SIGNATURE 10 Instructions For Use Manual

Set-up

1. Platter installation

Unscrew the three transport screws (14) from the aluminium sub-chassis before installing the sandwich platter
(4). Remove the protective covers from the bearing shaft and from the platter housing.
These covers shield against dust and dirt and keep the bearing shaft and housing sufficiently lubricated. If
necessary, lubricate the shaft with grease from the enclosed accessories. Maximum amount is 0,5 ml. Use the
scale on the supplied syringe to measure the desired quantity and distribute the lubricant evenly.
The platter is floating on magnets. Take care not to damage the magnet when putting
the platter on the shaft.
6
© Pro-Ject Audio Systems · Pro-Ject SIGNATURE 10 · Revision 2015.07.07