Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Note
f The magnification is not displayed in the moving screen.
f The digital zoom function is canceled if the input signal changes during a digital zoom.
f During a digital zoom, the freeze function is disabled.
f The digital zoom function may not work properly for some still image-based signals.
Using the presentation timer function
The presentation timer function can be operated.
Presentations, etc. can be performed while checking the elapsed time or time remaining in the preset time.
button
1)
Press the <P-TIMER> button.
f The count is started.
f The elapsed time or the remaining time is displayed at the bottom right of the projected image.
2)
Press the <P-TIMER> button again.
f The count is stopped.
3)
Press the <P-TIMER> button again.
f The count is resumed.
Note
f The presentation timer is ended by holding the <P-TIMER> button down for at least three seconds.
f For details such as presentation timer function settings, refer to [DISPLAY OPTION] menu → [P-TIMER] ( x page 90).
Using the FUNCTION button
Some operations in the menu can be assigned to the <FUNCTION> button on the remote control so that it can be
used as an easy shortcut button.
button
1)
Press the <FUNCTION> button.
To assign functions to the <FUNCTION> button
1)
Press the <MENU> button on the control panel or the remote control to display the menu items (main
menu, sub menu, or details menu) you want to assign.
f Refer to "Navigating through the menu" ( x page 62) for the operation of the on-screen menu.
2)
Press and hold the <FUNCTION> button for three seconds or more.
Note
f After settings have been completed, the assigned menu item (main menu, sub-menu, or details menu) will be displayed in [ASSIGNED
FUNCTION] of the operation guide under the menu.
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] ( x page 96) when deallocating
functions.
Displaying internal test patterns
The projector has ten types of internal test patterns to check the condition of the projector. To display test patterns,
perform the following steps.
button
1)
Press the <TEST PATTERN> button.
58 - ENGLISH
Advertisement
Table of Contents
