Table of Contents
Advertisement
f Pull out the air filter cover from the hook of the projector while slightly pushing upward the tabs of the air
filter cover and open it in the direction of the arrow in figure.
f When pulling open the air filter cover, be sure to firmly hold the air filter cover with your hand. Opening the
air filter cover quickly may result in the cover falling.
f Vacuum dust from the air filter with a vacuum cleaner.
3)
Remove the air filter unit.
f Pull out the air filter unit from the tabs of the projector while slightly pressing the knob at the center of the
frame at the connecting terminal side (rear side) inward as shown by the arrow, and remove the air filter
unit. (Fig. 2)
f After pulling out the air filter unit, remove foreign objects and dust from the air filter unit compartment and
the projector's air intake port if there are any.
Cleaning the air filter unit
Remove the air filter unit beforehand according to the previously described procedure in "Removing the air filter
unit".
1)
Wash the air filter unit. (Fig. 1)
i) Soak the air filter unit in cold or warm water and then lightly rinse it.
f Do not use cleaning tools such as brushes.
f When rinsing, hold the frame of the air filter unit without putting strong pressure on the filter.
ii) Rinse the air filter unit two or three times by using fresh water each time.
f Insufficient rinsing may result in odors.
2)
Dry the air filter unit. (Fig. 2)
f Let the air filter unit naturally dry off in a well-ventilated place where there is little dust and is not exposed to
direct sunlight.
f Do not dry using drying devices such as dryers.
f After the air filter unit is dried, proceed to "Attaching the air filter unit" ( x page 139).
Attaching the air filter unit
1)
Attach the air filter unit to the projector.
f Perform Step 3) in "Removing the air filter unit" in the reverse order.
f Push in the air filter unit securely until it clicks into place.
2)
Attach the air filter cover to the projector.
f Perform Step 2) in "Removing the air filter unit" in the reverse order to close the air filter cover, and push in
the air filter cover securely until it clicks into place.
f Make sure that the air filter cover is closed tightly.
Procedure of [FILTER COUNTER RESET]
1)
Connect the power plug, set the <MAIN POWER> switch to <ON>, and press the power button
<v/b> on the control panel or on the remote control to turn on the power and start the projection.
2)
Press the <MENU> button to display the main menu, then press as to select [PROJECTOR SETUP].
Chapter 6 Maintenance — Maintenance/replacement
Fig. 1
Fig. 2
ENGLISH - 139
Advertisement
Table of Contents
