Table of Contents
Advertisement
4)
Press qw to switch the item.
[KEEP CURRENT STATE]
[OPEN]
[CLOSE]
[AUTO SETUP SETTING]
Set the automatic execution of AUTO SETUP.
The screen display position or signal level can be adjusted automatically without pressing the <AUTO SETUP>
button on the remote control on each occasion if you input unregistered signals frequently at meetings, etc.
1)
Press as to select [AUTO SETUP SETTING].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[BUTTON]
[SIGNAL SEARCH]
When the power is turned on, this function automatically detects the terminal which signals are input and sets the
function to switch.
1)
Press as to select [SIGNAL SEARCH].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f If the [SIGNAL SEARCH] is set to [ON] when there is no signal input, press the <AUTO SETUP> button on the remote control, this function
automatically detects the terminal to which signals are input and then switches.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1)
Press as to select [STARTUP INPUT SELECT].
2)
Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3)
Press as to select an item.
f The items will switch each time you press the button.
[LAST USED]
[NETWORK]
[RGB1]
[RGB2]
[HDMI1]
[HDMI2]
[VIDEO]
[DIGITAL LINK]
*1
[INPUT1] ~
[INPUT10]
*1*2
*1 Only for PT-EZ590, PT-EW650 and PT-EX620
*2 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input name is
automatically reflected from [INPUT1] to [INPUT10]. If an item where the input name is not reflected is selected, it is disabled.
Note
f When [SIGNAL SEARCH] is set to [ON], the [STARTUP INPUT SELECT] cannot be set.
88 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
When the projector is switched off, the projector turns into standby with the shutter status left as is.
When the projector is switched off, the projector turns into standby with the shutter left opened.
When the projector is switched off, the projector turns into standby with the shutter left closed.
Enables the auto setup function when switching signals.
Enables the auto setup function only when the <AUTO SETUP> button is pressed.
Enables input detection automatically.
Disables input detection automatically.
Keeps the input selected last.
Sets the input to NETWORK.
Sets the input to RGB1.
Sets the input to RGB2.
Sets the input to HDMI1.
Sets the input to HDMI2.
Sets the input to VIDEO.
Sets the input to DIGITAL LINK.
Sets the input to DIGITAL LINK, and switches the input of Panasonic twisted-pair-cable transmitter to the
specified input.
Advertisement
Table of Contents
