Table of Contents
Advertisement
Switching the input by displaying the input guide
The input for projection can be selected by displaying the input guide with the control panel.
1)
Press the <INPUT SELECT> button on the control panel.
f The [DETAILED] input guide or the [SIMPLE] input guide is displayed. ( x page 81)
2)
Press the <INPUT SELECT> button again.
f The input will switch each time you press the <INPUT SELECT> button.
f You can also select the input source by pressing asqw on the remote control or the control panel from
the [DETAILED] input guide.
Note
f The input guide for [DETAILED]/[SIMPLE], you can change the setting from the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] →
[INPUT GUIDE].
Adjusting the focus, zoom and shift
If the projected image or the position is not correct when the positioning of the projector and the screen is correctly
installed, adjust the focus, zoom, and shift.
Using the control panel
1)
Press the <LENS> button on the control panel.
f Pressing the button changes the adjustment screen in the order of [FOCUS], [ZOOM] and [SHIFT].
2)
Select each item and press asqw to adjust it.
Using the remote control
1)
Press the lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons on the remote control.
f <FOCUS> button: Adjusts focus.
f <ZOOM> button: Adjusts zoom.
f <SHIFT> button: Adjusts shift.
2)
Select each item and press asqw to adjust it.
CAUTION
During the lens shift operation, do not insert your hand in any opening around the lens.
Your hand may be caught in between, resulting in injury.
Note
f The adjustment can be performed quickly by pressing and holding asqw for at least three seconds.
f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
f Only [FOCUS] is shown in yellow so that the displayed menu item can be recognized by color, even when the projector is not focused and
displayed characters are unreadable. (Factory default)
52 - ENGLISH
Chapter 3 Basic Operations — Projecting
The input guide for [DETAILED]
The input guide for [SIMPLE]
[DIGITAL LINK] input is only
for PT-EZ590, PT-EW650
and PT-EX620.
If there is no signal input ([RGB2], [HDMI1]
or [HDMI2]), this screen will be displayed.
Check the output settings of your computer.
Advertisement
Table of Contents
