Initial Screen - Toyota TNS 510 User Manual

BASIC FUNCTION

Initial screen

Vehicles with smart entry and start
system—
When the "ENGINE START STOP" switch
is in the ACCESSORY or IGNITION ON
mode, the initial screen will be displayed
and the system will begin operating.
Vehicles without smart entry and start
system—
When the engine switch is in ACC or ON
position, the initial screen will be displayed
and the system will begin operating.
ü
CAUTION
When the vehicle is stopped with the
engine running, always apply the
parking brake for safety.
After a few seconds, the "CAUTION"
screen will be displayed.
Read and follow the instructions.
When "Show map" is touched on
the screen, the map screen will be
displayed.
22 TNS 510
● Maintenance information
This system informs about when to replace
certain parts or components and shows
dealer information (if registered) on the
screen.
When the vehicle reaches a previously
set driving distance or date specified for
a scheduled maintenance check, the
1E5001G
"Information" screen will be displayed when
the navigation system is in operation.
To disable this screen, touch "Do not
display this message again.". This
screen goes off if the screen is not
operated for several seconds.
To prevent this information screen from
being displayed again, touch "Do not
display this message again.".
To register "Maintenance information", see
"Maintenance information" on page 120.
E1001GS
1E5005G