Table of Contents
Advertisement
AutoDome 600 Series Analog PTZ
Camera
Notice!
Up to five (5) anchor points can be used to form the area which you want to detect motion
within. Motion Detection is not activated until the Preset scene is recalled. The Motion
Detection icon "M" appears in the upper left-hand corner of the display.
7.6
Image Stabilization
Image Stabilization becomes increasingly important as zoom ranges are extended. The
advanced image stabilization algorithms of the VG5 Series AutoDome eliminate camera shake
for exceptional image clarity. Bosch achieves this clarity without reducing camera sensitivity or
picture quality.
–
–
7.7
Pre-position Tour
The VG5 Series AutoDome features (2) preset tours. Each preset scene is saved for playback
later.
Tour 1 is a standard tour that only recalls the scenes in the exact sequence they were shot.
Scenes can be added or deleted on the tour, but the sequence cannot be changed. To add or
remove scenes on Tour 1 enter the keyboard command SHOT-900-ENTER and follow the on-
screen instructions.
Tour 2 is a customizable tour that allows you to rearrange the sequence of scenes on the tour
by inserting and deleting scenes. To enter the Edit Tour 2 menu, enter the keyboard command
SET-900-ENTER and follow the on-screen instructions.
7.8
Azimuth, Elevation, and Compass Directions
The VG5 AutoDome allows a user to display the azimuth and elevation position, and the
compass heading of the camera. The AutoDome displays the position data in the lower-right
corner of the image display. These readings are described as:
Azimuth:
Elevation:
Compass:
The AutoDome uses the azimuth to determine the compass direction. The following table
shows the azimuth range and its corresponding compass heading:
Azimuth Range
21° to 65°
66° to 110°
111° to 155°
156° to 200°
201° to 245°
Bosch Security Systems, Inc.
To configure image stabilization, open the Main menu, select the Advanced menu, and
then select Stabilization to turn on the feature.
In Pelco Mode open the Main menu, select the Advanced menu, and then select
Stabilization to turn on the feature.
The pan angle from zero to 359 degrees in one degree increments. An azimuth
of zero degrees corresponds to North.
The tilt position from zero (horizon) to –90 degrees (camera pointing straight
down) in one degree increments.
The cardinal or intercardinal (N, NE, E, SE, S, SW, W, NW) heading in which the
camera is pointing.
Compass Direction
NE (Northeast)
E (East)
SE (Southeast)
S (South)
SW (Southwest)
User Manual
Advanced Features | en
57
2014.11 | 2.1 | F.01U.270.005
Advertisement
Table of Contents
