Getting Started; Powering On - Bosch VG5 600 Series User Manual

AutoDome 600 Series Analog PTZ
Camera
1

Getting Started

Install and wire the AutoDome according to the VG5 AutoDome Installation Manual. A typical
system includes a keyboard, matrix switcher, monitor, and appropriate wiring connections.
Please refer to the individual product manuals for complete installation and setup instructions
for each of the system components.
1.1

Powering On

When you turn the AutoDome power on there is a ten (10) second pause before the dome
starts its homing phase. During the homing phase the camera pans left and right and tilts up
and down. It also adjusts the lens focus. The entire homing phase lasts approximately 40
seconds and ends with a firmware version screen.
Bosch Security Sys. AutoDome(r)
600 Series
Day/Night 36X
SC Boot
FPGA
VCA_boot
STD Comm
No Heater
FastAddress: Not Set
Figure 1.1: Sample VG5 Startup Firmware Version Screen
The splash screen displays the type of AutoDome, the camera installed, the firmware levels for
various files, and the current IP address (for VG5 AutoDome 700 Series models).
Bosch Security Systems, Inc.
5.00.00.03/1.05.00.02
1.00.00.00
5.00.00.03
1.13.01.05
1.02.00.01
User Manual
Getting Started | en 5
2014.11 | 2.1 | F.01U.270.005