Panasonic KX-NS1000 User Manual page 339

Button
ISDN Service
Calling Line Identification
Restriction (CLIR)
Connected Line
Identification Restriction
(COLR)
ISDN-Hold
Headset
Time Service Switching
Mode (Automatic/Manual)
Network Direct Station
Selection (NDSS)
CTI
Primary Directory Number
(PDN)
Secondary Directory
Number (SDN)
Check-in
Check-out
Cleaned-up
Two-way Record
Select ISDN Service from Type.
Then enter the desired number in Dial (max. 32 digits consisting of 0–9,
#, T [Transfer], [ ] [Secret], P [Pause], and F [Flash]).
Note
Availability of this button depends on the ISDN service of your telephone
company.
Refer to "1.2.5 Accessing the ISDN Service (ISDN Service Access)".
Select CLIR from Type.
Select COLR from Type.
Select ISDN Hold from Type.
Select Headset from Type.
Select Time Service - Automatic/Manual from Type.
Then in Parameter Selection, select the Time Table (tenant number) to be
used when Time Service Switching Mode is set to Automatic.
Select NDSS from Type.
Then enter the another PBX extension number in Dial (max. 16 digits
consisting of 0–9).
Note
The button may not be available depending on the networking method in
use or the settings of the PBX.
Select CTI from Type.
Select PDN from Type.
Select SDN from Type.
Then enter the extension number in Extension Number.
In Parameter Selection, specify the delayed ringing setting for calls arriving
at an SDN button.
To specify the ring tone, select the ring tone type from Optional Parameter
(Ringing Tone Type Number).
Select Check In from Type.
Select Check Out from Type.
Select Cleaned Up from Type.
Select Two-way Record from Type.
Then enter the UM group's floating extension number in Extension
Number. (The UM group's default floating extension number is 500.
3.2.1 User Programming
Steps
,
)
*1
User Manual 339