Appendix; Opening The Terminal Cover; Removing The Terminal Cover; Mounting Of The Remote Control Holder - NEC PlasmaSync 50PD2 User Manual

Appendix

When connecting signal or other cables, the terminal cover of the monitor terminal section is opened to allow the connection to be made.
After making the connection, close the terminal cover to permit cables to be arranged.
Terminal cover
Tab
When connecting signal or other cables, it may not be possible to close the terminal cover of the monitor terminal section.
Should this be the case, the terminal cover can be removed for ease of use.
Mounting
portion
Terminal cover

Mounting of the Remote Control Holder

A remote control holder can be mounted which will allow the remote control to be stored away when it isn't being used.
Remote control
holder
1
2

Opening the Terminal Cover

Raise the tab at the side of the terminal cover and open the
1
terminal cover at the same time.
2
Release the tab.
Raise the tab at the side of the terminal cover and close the
1
terminal cover at the same time.
2
Release the tab.

Removing the Terminal Cover

Lift the mounting portion at the top of the terminal cover and
1
remove the terminal cover at the same time.
1
Insert the mounting portion at the bottom of the terminal cover.
Lift the top portion of the terminal cover and insert at the same
2
time.
Insert the top portion of the remote control holder into the
1
(upper side) mounting holes at the left of the monitor terminal
section.
Insert the bottom portion of the remote control holder into the
2
(lower side) mounting holes. (Insert until an engagement click is
heard.)
Removing the Remote Control Holder
Push up the bottom portion of the remote control holder and
1
disengage it.
2
Disengage the upper portion of the remote control holder.
Closing the Terminal Cover
Attaching the Terminal Cover
E-45
P M
LASMA ONITOR
†