Setup Procedure - NEC PlasmaSync 50PD2 User Manual

Setup Procedure

1
Determine the installation location
Installation of only the plasma monitor is not possible. Be sure to
use and install the plasma monitor in conjunction with a stand or
special unit.
DO NOT ATTEMPT TO INSTALL THE
CAUTION
PLASMA MONITOR.
Installing your plasma display must be done by a qualified tech-
nician. Contact your dealer for more information.
DO NOT USE THE RETRACTABLE FEET
CAUTION
FOR PURPOSE OF PERMANENT INSTAL-
LATION.
The retractable feet are for temporary use only and are not in-
tended for permanent installation.
MOVING OR INSTALLING THE PLASMA
CAUTION
MONITOR MUST BE DONE BY TWO OR
MORE PEOPLE.
Failure to follow this caution may result in injury if the plasma
monitor falls.
Important
Lay the protective sheet, which was wrapped around the plasma monitor
when it was packaged, beneath the plasma monitor so as not to scratch the
panel.
2
Install the plasma monitor
The connections of two or more plasma monitors may degrade
image quality on the remaining connected units connected to the
loop out. Consider the cable length or cable type to be used.
Note that only one plasma monitor connection is possible for loop-
out.
3
Install the remote control batteries
The remote control is powered by 1.5
V AA magnesium batteries.
To install or replace batteries:
¡ Press and slide to open the cover.
™ Align the batteries according to
the (+) and (–) indications inside
the case.
£ Replace the cover.
4
Connect external equipment
• To protect the connected equipment, turn off the main power
before making connections.
• Refer to your equipment user manual.
5
Connect the supplied power cable
• The power outlet socket should be installed as near to the equip-
ment as possible, and should be easily accessible.
• Attach the supplied ferrite core to the power cable. See page
50.
• Fully insert the prongs into the power outlet socket. Loose con-
nection may cause noise.
• The maximum power consumption 570 W (the maximum cur-
rent rating 6.0 A)
6
Switch on the power of all the attached external equipment
When connected with a computer, switch on the power of the com-
puter first.
7
Operate the attached external equipment.
Display the signal on the external equipment you wish.
8
Select the input mode
Select the appropriate input.
When the equipment is connected to the RGB 2/DVD/HD, make
the setting for the RGB 2 input. When an audio signal is connected,
make the setting for sound.
9
Adjust the sound
Make adjustments when adjustment of the volume or balance is
required.
10
Adjust the screen
Make adjustments when adjustment of the screen display position
or distortion is required.
11
Adjust the image
Make adjustments when picture adjustment such as the bright-
ness or contrast is required.
(See page 14)
(See pages 22 and 27)
(See page 27)
(See pages 31 and 32)
(See page 28)
13
P M
LASMA ONITOR
†