Connecting Your Macintosh Computer - NEC PlasmaSync 50PD2 User Manual

Table of Contents

Connections

Connecting your Macintosh computer to your Plasma monitor will enable you to display your

computer's screen image. Some video cards or drivers may not display images correctly. (See also "Signal Identification For Raster

Preset" on page 64.)

• To connect the RGB 1 IN connector (mini D-sub 15 pin) on the plasma monitor, use the supplied RGB signal cable (mini D-sub 15 pin to

mini D-sub 15 pin).

For older Macintosh, use a pin adapter for Macintosh (available separately) to connect to your Macintosh's video port.

The resolution modes that you can select are:

• 13" fixed mode

• To connect the RGB 2/DVD/HD IN connector (BNC) on the plasma monitor, use the signal cable available separately (mini D-sub 15 pin

to BNC x 5).

Select [RGB] for [RGB 2] from the INPUT SELECT menu.

When connecting one or more Plasma monitors, use the RGB 2/DVD/HD OUT connector (BNC).

• If you use with a Macintosh PowerBook, set "Mirroring" to Off.

Refer to your Macintosh's owner's manual for more information about your computer's video output requirements and any special

identification or configuring your monitor's image and monitor may require.

• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUND

menu.

Mini D-sub 15 pin

Pin adapter for

Macintosh

To video output port

Macintosh

LASMA

ONITOR

†