Basic Operation
Before operating the remote control, be sure to turn on the main power to the plasma monitor.
POWER OFF
RGB 2/DVD/HD
RGB 1
VIDEO
EXIT
POSITION/CONTROL
RP-102
POWER/STANDBY
VIDEO
RGB
UP
DOWN
PROCEED
EXIT
POWER ON
RGB 3
PROCEED
Turning on the Main Power and Return to Standby Mode
The plasma monitor enters the standby mode and the POWER/
STANDBY lamp is lit in orange when the power cable is plugged
into the wall outlet.
To turn the main power:
Press the POWER button on the front
panel of the plasma monitor
The main power will be turned on.
The POWER/STANDBY lamp is lit in green.
To turn off the power
(standby mode):
Press the POWER button again
The plasma monitor is in standby mode.
The POWER/STANDBY lamp is lit in or-
ange.
Turning On or Off the Power with the Remote Control
To turn on the plasma monitor:
Make sure that the POWER/STANDBY
lamp is lit in orange (standby).
Press the POWER ON button on the re-
mote control.
The plasma monitor is turned on.
The POWER/STANDBY lamp is lit in green.
To turn off the plasma monitor:
Press the POWER OFF button on the
remote control.
The plasma monitor enters the standby
mode.
The POWER/STANDBY lamp is lit in or-
ange.
* The standby mode used here is the condition that exists when
the power management is on. This is not the standby mode set
by the remote control's powering-off.
21
P
M
LASMA
ONITOR
†