Table of Contents
Advertisement
Parameter
Output Gain
Output Pan
Output Pan Mode
Demo Song
Pitch Bend Range Up and Down
Use these parameters to define how much the pitch will change when you move your Pitch
Wheel. For both Pitch Bend Range parameters, positive values will cause the pitch to bend
up, while negative values will cause the pitch to bend down. Large positive values can cause
samples to bend to their maximum upward pitch shift before the Pitch Wheel is fully up (or
down). This will not happen when bending pitch down.
Monophonic
When off, the program is polyphonic—it can play up to 128 notes at a time. Notice that
when the Monophonic parameter is off, the LegatoPlay parameter and the three Portamento
parameters do not appear on the COMMON page. This is because only monophonic
programs can use portamento.
When On, the program will play only one note at a time. This makes it possible to use and
to determine the behavior of the portamento feature. Do not set Ignore Release On (
6-20
) when you are using Monophonic programs, since the lack of Note Off messages will
prevent you from switching programs properly.
Legato Play
When Legato Play is on, a note will play its attack only when all other notes have been
released. This is useful for realistic instrumental sounds.
Range of Values
-96 to 24 decibels
± 64
Fixed, +MIDI
Demo Song List
Program Edit Mode
The COMMON Page
Default
0
0
+MIDI
0 None
page
7-17
Advertisement
Table of Contents
