Table of Contents
Advertisement
The DSP Modulation (DSPMOD) Page
Before reading further, be sure to read
Control Parameters on page
Press the DSPMOD soft button to call up the DSP Modulation (DSPMOD) page, which is
displayed below:
Each field in the left-hand column of the page is a function-parameter of the current layer's
algorithm. You can coarsely adjust the function-parameter in these left-hand fields—as noted
in
Common DSP Control
the DSPMOD page are reflected in the corresponding function-parameters on the DSPCTL
page. The right-hand side of the DSPCTL page is the subpage of the highlighted function-
parameter—on the subpage are the programmable parameters. To access the parameters on
the subpage, highlight the function-parameter you wish to edit, and then press the > button
to move the cursor into the subpage.
Each function-parameter's subpage contains the programmable parameters of the highlighted
function-parameter. By assigning control sources to modulate a function-parameter, you
can enable real-time control of your program's sound and behavior. You can assign Src1 to
any control source, and can specify its maximum value with the Depth parameter. Src2 is
different—you can assign it to any control source, but can also assign a control source to its
maximum value with the DptCtl parameter. You can then specify the range of Src2's depth
with the MinDepth and MaxDepth parameters.
7-32.
Parameter
Source 1
Depth
Source 2
Depth Control
Minimum Depth
Maximum Depth
Parameters, any adjustments made to the function-parameters on
The DSP Modulation (DSPMOD) Page
Algorithm Basics on page 7-31
Range of Values
Control Source List
(Depends on Function)
Control Source List
Control Source List
(Depends on Function)
(Depends on Function)
Program Edit Mode
and
Common DSP
Default
Off
0
Off
Off
0
0
7-39
Advertisement
Table of Contents
