Table of Contents
Advertisement
Program Edit Mode
The DSP Control (DSPCTL) Page
Each field in the left-hand column of the page is a function-parameter of the current layer's
algorithm. You can coarsely adjust the function-parameter in these left-hand fields—as noted
in
Common DSP Control
the DSPCTL page are reflected in the corresponding function-parameters on the DSPMOD
page. The right-hand side of the DSPCTL page is the subpage of the highlighted function-
parameter—on the subpage are the fine adjust parameters and hard-wired parameters. To
access the parameters on the subpage, highlight the function-parameter you wish to edit,
and then press the > button to move the cursor into the subpage.The label of a function-
parameter depends on its corresponding function-block in the current layer's algorithm. The
above DSPCTL page corresponds to the following algorithm:
7-38
Function
Parameter
Pitch
Fine Adjust
Hertz Adjust
Pitch
Key Tracking
Velocity Tracking
(Function)
(Function-Parameter)
(Function)
(Function-Parameter)
(Function)
(Function-Parameter)
(Function)
(Function-Parameter)
Level
Key Tracking
Level
Velocity Tracking
Parameters, any adjustments made to the function-parameters on
Range of Values
-128 to 127 semitones
± 100 cents
± 10.00 Hertz
± 2400 cents/key
± 7200 cents
(Depends on Function)
(Depends on Function)
(Depends on Function)
(Depends on Function)
-96 to 24 decibels
± 2.00 decibels/key
± 96 decibels
Default
0
0
0
0
0
(Depends on Function)
(Depends on Function)
(Depends on Function)
(Depends on Function)
-6
0
35
Advertisement
Table of Contents
